Pen Shaped Gas Soldering Iron Gas Soldering Iron Ht-1937 Gas Soldering Iron Aluminum Alloy Shell Gas Torch

Pen type gas 3-in-1 gas soldering iron HT-1937, with a burner, one portable Name: pen type gas soldering iron Model: HT-1937 Filling capacity: 12ML Temperature: flame temperature 1300 ℃, soldering iron temperature 450 ℃ Material: plastic+metal Power form: air inflation Overall dimension: 185 * 20 instructions 1、 Gas filling 1. Fill with high-quality gas, and make sure that the switch is turned off at OFF, and then replenish. 2. Guide the gas tank into the air hole, and press down to inflate. 3. It takes about 10 seconds to fill the gas. Wait a few minutes for the gas to stabilize before use. 4. If there is a hissing out sound at the tail after gas is injected, press the tip of the pen slightly into the gas port to eliminate it. 2、 Ignition 1. Replace the soldering head 2. Push the switch to the ON position and hear a "hissing" sound 3. Use an igniter or lighter to ignite near the connector. 4. Burn for 3 minutes after ignition. When the fire is extinguished, the soldering iron will continue to heat. 5. Adjust the flame size to make it larger in the direction of "ten" and smaller in the direction of "one". 6. The temperature of this product is up to 1300 ℃ (the temperature of the soldering iron is 450 ℃). Please pay attention to safety when using this product. Turn the switch OFF after use Location of. 7. When using the gas soldering iron, please pay special attention to wait until the flame is completely eliminated and the objects inside the soldering iron become red Small but not large, to prolong the life of the soldering head. 8. The length of the flame is about 1.2-2.2 cm. 3、 Precautions: 1. Replace the connector after cooling or replace it in advance. 2. The iron head in use is hot and hot. Please do not touch it with your hands. 3. The adjusting button can control the gas output and temperature, usually in the middle position. 4. After use, store it after cooling, and do not place it in high temperature or direct sunlight. 5. It is not suitable for children to use, and must be properly placed when collecting. 6. Please use high-quality canned gas to fill, and keep away from the fire source when filling. 7. It is necessary to clean the nozzle frequently because of the gas or slag. 8. When cleaning, the nozzle can be pressed on the gas outlet of the gas tank to achieve cleaning effect. 9. Avoid heavy falls. 10. Do not attempt disassembly or repair under any circumstances.